Fischer 501419 Piercing anchor FAZ II 12/50 stainless steel A4 20 pieces

Fischer 501419 Doorsteekanker FAZ II 12/50 roestvast staal A4 20 pieces

The stainless steel bolt anchor for the very toughest requirements in concrete. Strong and flexible. Strong and flexible. The fischer Piercing anchor FAZ II A4 is the stainless steel anchor for the highest demands. With this anchor, heavy loads are fixed in cracked concrete. Thanks to its simple assembly, the FAZ II A4 can be used particularly flexibly. The proven spreader clip guides the loads particularly reliably into the concrete and ensures the highest load-bearing capacity. With the stainless steel version, loads are fixed outdoors. For example, the steel anchor is ideally suited for fixing railings, consoles, steel structures and gates.

Advantages

• With the proven spreader clip, the largest load capacities are possible. therefore, fewer attachment points and smaller anchor plates are required.
• Fewer hammer blows and minimal tightening slip make for noticeably easier and comfortable application.
• International approvals guarantee optimum safety and best performance. Applications in earthquake zones (Seismik) are also covered by these approvals.

Characteristics

• Strong attachment: The spreader clip guaranteed the greatest load capacity.
• Fewer attachment points and smaller anchor plates save time and cost.
• Easy assembly: fewer hammer blows and minimal tightening slip.
• This saves time and power.
• Stainless steel: maximum safety for outdoors.

Applications

• Steel structures, Railings, Consoles, Ladders, Cable trays, Machinery, Stairs, Fencing, Facade systems, Wood structures.

Building Materials

• Approved for: Concrete C20/25 to C50/60, cracked and uncracked
• Also suitable for: Concrete C12/15 Concrete C80/95 (classification available)

Approval

• ETA-05/0069 DoP No. 0009 DoP No. 0081 DoP No. 0121 DoP No. 0756-CPD-0062 ESR-2948

Assembly

• The FAZ II is suitable for push-through and front mounting; also suitable for remote mounting under certain conditions.
• Prior to mounting, place the hex nut in the optimum position (the insertion pin protrudes approx. 3 mm from the hex nut).
• When torque is applied, the cone bolt is pulled into the spreader clamp, clamping it against the borehole wall.
• The head relief allows easy use of the anchor.
• For serial installation, we recommend the use of the FABS anchor bolt mounting attachment.

Technical data

• Approval ICC approval
• Seismic-approval C1/C2
• Drill hole diameter d0 12 [mm]
• Min. hole depth for through-hole mounting h2 140 [mm]
• Plug length l 150 [mm]
• Max. useful length lift,stand/lift,red tfix 50/70 [mm].
• Thread Ø x length M 12 x 101 [mm].
• Wrench size SW 19 [mm].

Includes

• 20 pieces