Fischer 501423 Through Bolt anchor FAZ II 16/25 stainless steel A4 20 pcs

Fischer 501423 Through Bolt anchor FAZ II 16/25 stainless steel A4 20 pcs

The stainless steel bolt anchor for the toughest demands in concrete. Strong and flexible. Strong and flexible. The fischer Piercing Anchor FAZ II A4 is the stainless steel anchor for the toughest demands. This anchor is used to secure heavy loads in cracked concrete. Thanks to the easy assembly, the FAZ II A4 can be used very flexibly. The proven spreader clip guides the loads particularly reliably into the concrete and ensures the highest load capacity. With the stainless steel version, loads are secured outdoors. The steel anchor is ideally suited, for example, to the fixing of railings, consoles, steel constructions and gates.

Benefits

• The proven staggered clip allows the highest load capacities, so fewer fastening points and smaller anchor plates are required
• Fewer hammer blows and minimal tightening slippage make for noticeably easier and more comfortable application
• The international approvals guarantee optimum safety and the best performance. Applications in earthquake zones (Seismik) are also covered by these approvals

Characteristic properties

• Strong fastening: The spreader clip guarantees the greatest load capacity
• Fewer attachment points and smaller anchor plates save time and money
• Easy assembly: fewer hammer blows and minimal tightening slippage
• This saves time and power
• Stainless steel: maximum safety for outdoors

Applications

• Steel constructions, Railings, Consoles, Ladders, Cable trays, Machinery, Stairs, Fencing, Facade systems, Timber constructions

Building materials

• Approved for: Concrete C20/25 to C50/60, cracked and uncracked
• Also suitable for: Concrete C12/15 Concrete C80/95 (classification available)

Approval

• ETA-05/0069 DoP No 0009 DoP No 0081 DoP No 0121 DoP No 0756-CPD-0062 ESR-2948

Montage

• The FAZ II is suitable for push-through and frontal mounting; also suitable for remote mounting under certain conditions
• Prior to assembly, set the hex nut to the optimum position (the pin protrudes approx. 3 mm from the hex nut)
• When torque is applied, the cone bolt is pulled into the spreader clamp, clamping it against the borehole wall
• The head relief allows for easy use of the anchor
• In case of a batch installation, we recommend using the FABS anchor bolt assembly tool

Specifications

• ICC Approval
• Seismic approval C1/C2
• Borehole diameter d0 16 [mm]
• Min. borehole depth for through hole mounting h2 135 [mm]
• Plough length l 148 [mm]
• Max. useful length lift,stand/lift,red tfix 25/45 [mm]
• Thread Ø x length M 16 x 84 [mm]
• Wrench size SW 24 [mm]

Includes

• 20 pieces