Fischer 95836 Through Bolt anchor FAZ II 16/25 electrolytically galvanised steel 10 pieces

Fischer 95836 Bolt anchor FAZ II 16/25 electrolytically galvanised steel 10 pieces

The anchor bolt for the toughest demands in concrete.

Strong and flexible. The fischer Piercing Anchor FAZ II is the steel anchor for the toughest requirements. It is used to secure heavy loads in cracked concrete. Thanks to its easy assembly, the FAZ II is very flexible. The proven spread clip guides the loads particularly reliably into the concrete and ensures maximum load capacity. With the galvanised steel version, loads are secured indoors. The steel anchor is ideally suited, for example, to the fixing of handrails, cable ducts and consoles.

Benefits

• The proven staggered clip allows the highest load capacities, so fewer fastening points and smaller anchor plates are required
• Fewer hammer blows and minimal tightening slippage make for noticeably easier and more comfortable application
• The international approvals guarantee optimum safety and the best performance.
• Applications in earthquake zones are also covered by these approvals

Characteristic properties

• With staggered clip for maximum load capacity: this requires fewer fastening points and smaller anchor plates.
• This saves time and money
• Minimal tightening lip.
• Easy assembly reduces time and effort
• With approval for cracked concrete and fire inspection: maximum safety

Applications

• Steel constructions, Railings, Consoles, Ladders, Cable trays, Machinery, Stairs, Fencing, Facade systems, Timber constructions

Building materials

• Approved for: Concrete C20/25 to C50/60, cracked and uncracked
• Also suitable for: Concrete C12/15 Concrete C80/95 (classification available)

Approval

• ETA-05/0069 DoP No 0009 DoP No 0081 DoP No 0121 DoP No 0756-CPD-0062 ESR-2948

Montage

• The FAZ II is suitable for push-through and frontal mounting; also suitable for remote mounting under certain conditions
• Prior to assembly, set the hex nut to the optimum position (the pin protrudes approx. 3 mm from the hex nut)
• When torque is applied, the cone bolt is pulled into the spreader clamp, clamping it against the drill hole wall
• The head relief allows for easy use of the anchor
• In case of a batch installation, we recommend using the FABS anchor bolt assembly tool

Technical data

• ICC Approval
• Seismic approval C1/C2
• Drill hole diameter d0 16 [mm]
• Min. Drill hole depth for through hole mounting h2 135 [mm]
• Plough length l 148 [mm]
• Max. useful length lift,stand/lift,red tfix 25/45 [mm]
• Thread Ø x length M 16 x 84 [mm]
• Wrench size SW 24 [mm]

Includes

• 10 pieces