Fischer 40669 Bolt anchor FBN II 8/20 electrolytically galvanised steel 50 pcs

Fischer 40669 Bolt anchor FBN II 8/20 electrolytically galvanised steel 50 pcs

The efficient fixing for flexible fixing in uncracked concrete. The fischer Quick Fix anchor FBN II is a steel anchor for efficient fixing in uncracked concrete. With its long threads and two anchoring depths the fischer Quick Fix anchor FBN II can be used particularly flexibly. In addition to front and rear fixing, the Quick Fix anchor is also suitable for distance fixing. The galvanised version of the Quick Fix anchor is suitable for securing handrails, consoles and cable ducts in interior fitting.

Benefits

• The standard anchoring depth reaches the maximum load values. As a result, fewer anchor points and smaller anchor plates are required
• The reduced anchoring depth results in a smaller Drill hole depth. This allows for shorter installation times and greater flexibility
• The long thread ensures balanced component tolerances and allows for spacer mounts, providing greater flexibility
• Fewer hammer blows and minimal torque slip allow for much easier assembly
• The plug-in pin protects the screw thread from damage and therefore enables faster installation and removal of the fastener

Characteristic properties

• With the standard anchoring depth, the FBN II achieves the highest load capacity. This means fewer fastening points and smaller anchor plates
• When using the reduced anchoring depth, the depth of the drill hole is reduced and installation is simplified
• The long threads compensate for component tolerances. In addition, the FBN II is suitable for remote mounting. This increases flexibility
• Easy assembly due to fewer hammer blows and minimal slippage
• The notch protects the thread from damage. This saves time during assembly and disassembly

Applications

• Steel constructions, Railings, Consoles, Ladders, Machinery, Fencing, Facade systems, Building materials,
• Approved for: Concrete C20/25 to C50/60, uncracked Also suitable for: Concrete C12/15 High density natural stone
• Approval ETA-07/0211 DoP No. 0015 DoP No. 0756-CPD-0296 GS 3.2/18-082-1-r1

Montage

• The FBN II is suitable for push-through and through-body mounting; also suitable for remote mounting under certain conditions
• Prior to assembly, set the hex nut to the optimum position (the pin protrudes approx. 3 mm from the hex nut)
• When torque is applied, the cone bolt is pulled into the spreader clamp, clamping it against the drill hole wall
• The head relief allows for easy use of the anchor
• In case of a batch installation, we recommend using the FABS anchor bolt assembly tool

Technical data

• Approval
• Drill hole diameter d0 8 [mm]
• Min. Drill hole depth for through hole mounting h2 76 [mm]
• Plug length l 81 [mm]
• Max. useful length lift,stand/lift,red tfix 20/30 [mm]
• Thread Ø x length M 8 x 49 [mm]
• Wrench size SW 13 [mm]

Includes

• 50 pieces