Fischer 40943 Quick anchor FBN II 10/100 (10X176) electrolytically galvanised steel 20 pieces

Fischer 40943 Quick anchor FBN II 10/100 (10X176) electrolytically galvanised steel 20 pieces

The Fischer Quick Fix Anchor FBN II is a steel anchor for efficient fixing in uncracked concrete. The long thread and two anchorage depths make the Fischer Quick Fix Anchor FBN II particularly flexible. In addition to front and rear fixing, the FBN II is also suitable for distance fixing. The galvanised version of the Quick Fix Anchor is suitable for fixing handrails, consoles and cable ducts in interior construction.

Benefits

• The standard anchoring depth ensures the highest load-bearing capacity, so that fewer fastening points and smaller anchor plates are required
• The reduced anchoring depth reduces the depth of the drill hole. This reduces the installation effort and increases flexibility
• In addition, the anchor is also ideally suited to large thicknesses of assembly pieces
• The long thread allows compensation of tolerances of components and remotely mounted structures, thus increasing flexibility
• Fewer hammer blows and minimal tightening slippage make assembly noticeably easier
• The insertion ridge protects the screw thread from damage and thus saves time during assembly and disassembly of the assembly piece

Applications

• Concrete C20/25 to C50/60, uncracked
• Concrete C12/15
• High density natural stone

Building materials

• The FBN II is suitable for push-through and through-hole mounting; also suitable for remote mounting under certain conditions
• Before assembly, set hexagon nut in the optimum position (the pin protrudes approx. 3 mm from the hexagon nut)
• When torque is applied, the cone bolt is drawn into the spreader clamp, thus clamping it against the Drill hole wall
• The head relief enables easy use of the anchor
• In case of a batch installation, we recommend using the FABS anchor bolt assembly tool

Technical data

• Approval : relevant
• Drill hole diameter : 10 mm
• Min. Drill hole depth for through hole mounting : 168 mm
• Plough length : 176 mm
• Max. useful length lift,stand/lift,red : 100/110 mm
• Wire : M 10 x 136 mm
• Wrench size : 17 mm
• Contents : 20