Fischer 512153 insulating plug DHK 200 for soft insulation 100 pcs.

Fischer 512153 insulating plug DHK 200 for soft insulation 100 pcs.

The Fischer DHK insulation plug is an efficient plastic insulation plug for insulation boards with low compression resistance. The DHK is pushed through the hole with a hammer. The ribs in the drilled hole tighten and the DHK is pressed optimally against the wall. The Fischer Isolation Jackhammer DHK is suitable for anchoring insulation boards in solid and perforated brick, concrete and aerated concrete.

Benefits

• The improved geometry of the spreader section allows for a low anchoring depth and therefore less drilling is required
• Flexible pins in the plate area adapt to the insulation material and guarantee permanent contact pressure
• The simple stroke assembly enables a quick assembly process and reduces the workload
• The colour of the DHK means that it does not stand out from black cladding in rear-ventilated facades

Applications

• Concrete
• Lightweight concrete hollow block
• Perforated brick
• Perforated sand-lime brick
• Solid sand-lime brick
• High density natural stone
• Cellenbeton
• Solid brick van lichtbeton
• Solid brick

Building materials

• The DHK is set with a hammer in push-through assembly
• The sheet size of the insulating plug must be selected according to the compressive strength of the insulating material: DHK 45 for pressure-resistant; DHK 90 for soft insulation materials
• The distribution of the ribs in the borehole gives the DHK an ideal contact pressure
• Temperature pressure at installation: -40 °C to 80 °C

Specifications

• Borehole diameter : 8 mm
• Min. drill depth : 30 mm
• Min. anchoring depth : 20 mm
• Plough length : 225 mm
• Max. thickness of attachment : 200 mm
• Content : 100