Fluke 4325181 1625-2 Geo-earthed test set

Fluke 4325181 1625-2 Geo-earthed test set

Features

• The Fluke 1625-2 Geo-grounding tester measures electrodelessly
• Research has shown that as many as 15 percent of power quality problems are related to poor grounding
• Fluke''s new grounding testers identify poorly grounded systems and help increase uptime
• The Fluke 1625-2 Geo-grounding tester helps technicians and electricians comply with electrical codes, engineering standards, and local regulations
• In this way they ensure that in the event of a lightning strike or during mains voltage peaks the current can find a safe path to earth
• The Fluke 1625-2 Geo-grounding tester can measure loop resistance in ground systems using only current probes
• In this test method, two current clamps are placed around the grounding pin and each clamp is connected to the tester
• No ground electrodes are used
• One current clamp induces a known, fixed voltage and the current is then measured by the other current clamp
• The tester then automatically determines the resistance of the grounding pin
• This measurement method only works if a connected grounding system is present for the building or structure being tested, but this is usually the case
• If there is only one earth connection, as is the case in many homes, the electrodeless method will not provide an acceptable value and the potential loss test method should be used
• For an electrodeless measurement, the grounding pin does not need to be disconnected
• This keeps the connected ground system intact during measurement
• The time-consuming placement and connection of electrodes for each earthing pin on the system is a thing of the past; a significant time saving
• You can also perform the grounding tests in places that were not previously considered, namely inside buildings, in high-voltage pylons and anywhere else where you do not have access to the ground
• The Fluke 1625-2 is a unique earth ground tester that can perform all four types of earth ground measurements: 3- and 4-pole potential loss test (using electrodes) 4-pole soil resistance test (using electrodes)
• Selective test (using 1 clamp meter and electrodes)
• Elektrodeloze test (met alleen 2 current clamps)
• The Fluke 1625-2 has advanced features including Automatic Frequency Control (AFC), which identifies existing interference and selects a measurement frequency for more accurate readings
• R* measurement, which measures ground impedance at 55 Hz for a more accurate reflection of the resistance that would result from a ground fault; adjustable limits for faster testing; battery status on display
• The Fluke 1625-2 is also easy to use
• For each measurement, the tester indicates which electrodes or current clamps should be connected
• The large rotary switch can be used even when wearing gloves
• The Fluke 1625-2 is IP56 rated for outdoor use
• Data storage and transfer via USB

Includes

• Fluke 1625-2 Geo-grounding tester
• User Manual
• Batteries
• Quick guide
• USB cable
• 2 current clamps
• C1620 professional carrying case
• 4 ground electrodes
• 3 wire reels