Gedore 8116370 1.06/HSP3 Hydraulic spindle 15 t

Gedore 8116370 1.06/HSP3 Hydraulic spindle 15 t

Features

• Vfor controlled and safe disconnection
• Designed for a pressure force of 10 t, 12 t or 15 t
  the pressure piece can be replaced by a point and extended if necessary.
  The small pressure spindle is protected by an anti-twist device against unintentional turning.
  
  Making ready for use
• 1. Before use, check that the thin pressure spindle is screwed out of the cap far enough so that the pressure piece is in its starting position in the hydraulic cylinder
• 2. Unscrew the cap from the spindle housing. To do this, unscrew the retaining screw
• 3. Screw the spindle body from below into the tractor''s traverse until it protrudes approx. 60 mm from the traverse
• 4. Screw the cap onto the main spindle as far as it will go, tighten the retaining screw. Application and procedure: e.g. HSP3
• 5. Apply the trigger and pre-tension the main spindle with a ring spanner or an open-end wrench
• 6. Screw the thin pressure spindle into the cap. The hydraulic mechanism now does its work. The stroke of the pressure piece in the hydraulic cylinder is max. 12 mm. The hydraulically loosened component can then be completely removed by tightening the main spindle with the cap
• 7. After use, turn the thin pressure spindle back to the starting position and push the pressure piece back into the hydraulic cylinder

Ownshelves

• Pressure force 33Nm
• Head height (a a1 b h L2 t) 125 mm
• Length (L L1) 465 mm
• useful spindle length165 mm
• Press force (kN) 100 kN
• Stroke 17 mm
• Key size 2 41 mm
• Key size hexagon 12 mm
• Spindle size (thread pitch x length)1 inch