Griffon 6306289 PolyMax Pro Power express white 435g

Griffon 6306289 PolyMax Pro Power express white 435g

Special features

• Very high final strength
• Very fast strength build-up
• Permanently elastic
• Very good filling power
• Good standing ability
• does not shrink, 100% glue
• Solvent-free
• Does not stain the edges
• Weatherproof
• Temperature resistant from -40°C to +100°C
• Paintable
• Curing approx. 2 mm/24 hours
• Solvent-free assembly adhesive with very high final strength and very fast strength build-up based on SMP Polymer
• For bonding and mounting many building materials on virtually all substrates, such as wood, (natural) stone, (gas) concrete, metal, rigid foam and various plastics
• Suitable for interior and exterior applications, such as battens, baseboards, skirting boards, window sills and sheet and insulation materials
• For all professional applications, such as facade and interior construction, residential, commercial and bodywork construction

Technical data

• Not suitable for PE, PP, PTFE, pure gypsum, and bitumen. When bonding plastics, always conduct an adhesion test first. Adhesion to plastic can vary depending on the type of plastic and the quality of the plastic
• Remove wet adhesive residues immediately with white spirit. Dried adhesive residue can only be removed mechanically.
• Consumption: For dotwise bonding: 5-8 m²/kg. Streaks: 1 tube yields approx. 8-15 meters of adhesive (depending on diameter of nozzle cut off)
• Store dry in closed packaging between +5°C and +25°C
• Content: 435 g

User Manual

• Cut thread, assemble nozzle and cut to a diameter of min. 0.5 cm
• Apply adhesive evenly, depending on the weight of the material, every 10 to 40 cm in vertical stripes or dots
• Always apply adhesive at corners and along edges
• Mount materials directly with a sliding motion and press or tap firmly. Correcting is still possible
• For heavy materials, fix or support if necessary
• Close tube tightly immediately after use
• The temperature of environment, adhesive and materials to be bonded should not be lower than +5°C
• Parts must be clean, dust- and grease-free. Provide a firm substrate. Substrate may be slightly moist. Use of primer not necessary.