Pferd 43198002 POS round brush single-row RBU Ø 50x15 mm shank Ø 6 mm stainless steel wire Ø 0.20

Pferd 43198002 POS round brush untrimmed RBU Ø 50x15 mm shank Ø 6 mm stainless steel wire Ø 0.20

Features

• Universally suitable for cleaning, de-rusting, levelling, cleaning of welds, light deburring and removal of corrosion and lacquers
• In order to meet the special requirements for machining stainless steel (INOX), PFERD uses wire quality 1.4310 (V2A) for all INOX brushes.
• Practical experience from the industrial environment confirms that this wire quality achieves very good corrosion resistance at optimum service life
• All PFERD brushes with INOX coatings are marked in blue and are suitable for use on all stainless steels (INOX), e.g.
• V4A
• The wire grade 1.4310 tends to have ferromagnetic behavior when cold-strengthened, that is, it is attracted by magnets
• Cause is a structural change, which is caused by deformation, e.g., during wire drawing
• This does not affect the quality and corrosion resistance of the INOX plating
• The overlay retains its corrosion-resistant properties;Cause is a structural change, which is caused by deformation, e.g. during wire drawing
• This does not affect the quality and corrosion resistance of the INOX plating
• The topping retains its corrosion resistant properties
• Stainless steel wire (INOX) withstands temperatures up to 450 °C

Technical Data

• Cover material: Stainless steel wire (INOX)
• Machinable materials: Aluminum
• Workable materials 1: Bronze
• Machinable materials 2: Cobalt base alloys
• Machinable materials 3: Non-ferrous metal hard
• Machinable materials 4: Heat-resistant materials
• Machinable materials 5: Nickel-based alloys (e.g., Inconel and Hastelloy)
• Machinable materials 6: Nickel- or titanium-based superalloys
• Machinable materials 7: Other non-ferrous metals
• Machinable materials 8: soft titanium alloys (tensile strength 500 N/mm²)
• Machinable materials 9: Stainless steel (INOX)
• Machinable materials 10: Titanium
• Machinable materials 11: Titanium alloys
• Width: 15 mm
• Ø trim material: 0.2 mm
• Ø outside: 50 mm
• Pin diameter: 6 mm