Virutex 9200400 FR292R Edge router.

Virutex FR292R Edge router.

The only router capable of milling down the edges of panels, straight or at an angle, without replacing the router bit

Special Features FR292FR

• Its wide base gives good guidance and allows you to rout easily.
• It gives you a whole range of additional milling possibilities, thanks to its unique tilt and adjustment system.
• Equipped with a powerful 750 W motor with electronic speed control and constant torque control for constant motor speed while working. External dust connection.
• Easier and more accurate routing work with the special 90° cutter:
• The body of the machine can be tilted to approximately 46.5° so that the side of the cutter is at 1.5° to the surface, thus avoiding damage when routing edges.
• If you have routed the protruding edge of the top and bottom of the panel, you can trim the glued edges with an easy adjustment of the machine, and if you tilt the machine to 45°, you can edge flat.
• Milling with the straight cutter: The tilting motor allows you to mill straight edges with the straight cutter (included as standard) as well as protruding edges.
• Excess panel material is routed with the body in the vertical position and the edges with the body tilted at 91.5° i.e. at 1.5° below the surface to avoid damage.

Technical data FR 292 FR

• Double insulation Input power: 750 W
• Max. routing diameter: 25 mm
• Collet 8 mm
• Spindle speed: 14.000-30.000 / min
• Weight: 2.2 Kg

Standard included:

• 90 º Cutter for trimming and creasing (1140087)
• Straight cutter Ø 18 mm for trimming and creasing (1140016)
• Collet 8 mm
• Copying tool with ball bearing
• Guide
• Case